#Minicom ttyusb0 install
#Minicom ttyusb0 serial

If you are having trouble, for example if you can only receive data from the device but can't send data, then try changing the Hardware Flow Control option to No.

#Minicom ttyusb0 serial

First we need to setup serial communication parameters on devices: /dev/ttyS0 and /dev/ttyUSB0. Go to the Save setup as dfl section and press enter to save the current configuration, then select exit. After connecting the cable, you can use utility programs cat and hexdump to start viewing results: In this example the DTE Serial Tap (NST Probe) is connected to serial device: /dev/ttyS1 and the DCE Serial Tap (Magellan Color GPS) is connected to serial device: /dev/ttyUSB0.Note: If you are using a USB to serial adapter use ttyUSB0 instead of tty0. Select the correct serial port (tty0 by default) by selecting option A.Go to the Serial port setup section and you will see a screen like the following:.In a terminal run the following command:.Then select Serial Port Setup and change the Serial Device (Option A) to /dev/ttyUSB0, or whatever your device file is as it slightly differs per distro.

#Minicom ttyusb0 install

If not installed use the following command: Setting up Minicom Choose Serial Port Setup Set A: Serial Device to /dev/ttyUSB0 or /dev/ttyS0 depending on which serial device you want to use. So install minicom (yum install minicom) then enter its settings (minicom -s).